Outdoor installation: Outdoor installation is subject to wind,strip light wind and rain. If 3M glue is used to fix it, the 3M glue will decrease over time and cause the LED light strip to fall off. したがって,strip light outdoor installation often uses a card slot fixing method,strip light which requires cutting and The connection method is the same as indoor installation,strip light but it needs to be equipped with waterproof glue to consolidate the waterproof effect of the connection point.
Power connection method: The general voltage of the LED strip is 12V DC,strip light so it needs to use a switching power supply. The size of the power supply is determined according to the power and connection length of the LED strip. If you don’t want each LED strip to be controlled by a power supply, you can buy a relatively large switching power supply as the total power supply,strip light and then connect all the LED strip input power supplies in parallel (the wire size can be extended if the wire size is not enough),strip light unified Powered by the main switching power supply. The advantage of this is that it can be controlled centrally. In addition to the inconvenience,strip light it is manifested in the inability to achieve the lighting effect and switch control of a single LED strip. The specific method can be measured by yourself.
